BB-1-Rider Blade Blocker
Operator controlled mower deck discharge baffle for Riding Mowers and most Stand-on Mowers

Patent #6382891

The first and only discharge baffle designed to maintain compliance by operating in conjunction with the factory installed discharge shield on your mower.

With Blade Blockeron your mower you can quickly open and close the baffle from your seat. Just think, no more blowing grass clippings off of mulched areas or vehicles. Your properties will look much better the first time you use Blade Blocker, and your labor to clean up will be considerably reduced! Best of all your customers will not complain about grass clippings in freshly mulched areas. The unique design incorporates a multitude of features that provide versatility and adjustability. Blade Blocker installs on practically any "zero turn" or "stand on" mower.

Walk behind version available

Baffle in the lowered (closed position) blocks the discharge opening. Discharge shield is shown raised for illustration purposes only. One half inch thick HDPE (high density polyethylene) is used for the baffle. Although practically indestructable, it is easily cut with a hack saw to custom fit your mower's discharge opening.	A small notch in the discharge deflector is the only modification required on most mowers. the baffle can then be opperated without any effect on the deflector.
Linkage adjustments allow the baffle to be set from an almost fully closed position to a fully open setting, or anywhere between. This allows the baffle to open parallel with the discharge shield when the baffle is in the raised position without lifting the shield. High quality linkage assembly compensates for missalignment and assures tight "no play" connections.	With the discharge chute raised the Blade Blocker baffle can be flipped into a fully vertical position when transporting the mower on a trailer.

Having installation trouble?
Click Here to see the BB-1 installed on various mowers.
Click here to see the instructions for the BB-1 Walk Behind Generation 1 (pre Spring '05)
Click here to see instructions for the BB-1 Rider, Generation 2 (post Spring '05)

Note: Discharge chute in photos is shown in the raised position for illustration purposes only.
Blade Blocker is designed to operate in conjunction with the discharge deflector shield on the mower.
Blade Blocker is not intended to be used as a mulching plate or in the place of the discharge shield. Its purpose is to temporarily block the discharge opening in order to prevent large volumes of grass clippings from being discharged onto areas where they are not desired.

Home | All Products | Open Trailer | Enclosed Trailer | Sulkies | Blade Blocker
| Videos | Links | Instructions | Warranties | TT's Tips | E-mail Us