Chute Blocker for Riding Mowers, Stand-On, Zero Turn Mowers
Call Now

BB-1 Rider Blade Blocker for Riding Mowers

 

Chute Blocker, BB-1 Rider Blade Blocker

 

Instructions

    • BB-1 Rider Page 1
    • BB-1 Rider Page 2

Having installation trouble? Click here to see the Blade Blocker installed on riding mowers.

 

MSRP - $ 299.95

Buy Chute Blocer for Zero Turn Mowers - Online - Trimmertrap

 

Patent #6874309

 

The first and only discharge baffle designed to maintain compliance by operating in conjunction with the factory installed discharge shield on your mower.

 

With Blade Blocker on your mower you can quickly open and close the baffle from your seat. Just think, no more blowing grass clippings off of mulched areas or vehicles. Your properties will look much better the first time you use Blade Blocker, and your labor to clean up will be considerably reduced! Best of all your customers will not complain about grass clippings in freshly mulched areas. The unique design incorporates a multitude of features that provide versatility and adjustability. Blade Blocker installs on practically any "zero turn" or "stand on" mower.

 

Walk behind version available.

 

If you're not sure where to purchase our products, give us a call at (800) 279-8727 and we'll make sure you get your products quickly and easily. If you have a question or special request, just click here and fill out our short form detailing your question. We'll get back to you promptly.

 

Send us your pictures of your Blade Blocker installations so we can share them with everyone!

 

 

Chute Blocker

Baffle in the lowered (closed position) blocks the discharge opening. Discharge shield is shown raised for illustration purposes only. One half inch thick HDPE (high density polyethylene) is used for the baffle. Although practically indestructible, it is easily cut with a hack saw to custom fit your mower's discharge opening

Chute Blocker

Linkage adjustments allow the baffle to be set from an almost fully closed position to a fully open setting, or anywhere between. This allows the baffle to open parallel with the discharge shield when the baffle is in the raised position without lifting the shield. High quality linkage assembly compensates for misalignment and assures tight "no play" connections.

 

Chute Blocker

A small notch in the discharge deflector is the only modification required on most mowers. the baffle can then be operated without any effect on the deflector

Chute Blocker

With the discharge chute raised the Blade Blocker baffle can be flipped into a fully vertical position when transporting the mower on a trailer.

 

A unique feature of the baffle material is that it can be heat formed to match a curved portion of the mower’s discharge opening if required. To shape the baffle, use a heat source such as a heat gun, to heat the area which needs to be formed. After heating the baffle, it can then be formed to the required shape. Following cool down, the baffle will retain its formed shape.

Chute Blocker Installation

Chute Blocker Installation

 

Chute Blocker Installation

Chute Blocker Installation

 

Notes:

Discharge chute in photos is shown in the raised position for illustration purposes only. The pictures above are illustrations ONLY. Discharge chutes will need to be notched for proper operation.

Blade Blocker is designed to operate in conjunction with the discharge deflector shield on the mower.

Blade Blocker is not intended to be used as a mulching plate or in the place of the discharge shield. Its purpose is to temporarily block the discharge opening in order to prevent large volumes of grass clippings from being discharged onto areas where they are not desired.

 

Call us at (800) 279-8727

Click here for our Question / Special Request form!

 

>