WC-1 Water Cooler Rack use and installation instructions.
IMPORTANT MUST READ !!!

The WC-1 must be attached using a minimum of three 5/16" grade" 5 " bolts and self locking nuts. A series of holes in the racks bottom and back sections can be used for this purpose. Four vertical slots in the back section must be kept open for installation of the included straps. It is the users sole responsibility to insure that the rack is mounted in a manor and location to adequately support and secure the cooler. Unlike other products on the market, the WC-1 was designed to secure different size coolers up to five gallons, and under certain conditions, larger sizes. If the WC-1 is to be used with coolers larger than five gallons, it must be attached using both the bottom and back sections. Both bottom and back sections must also be supported at the attachment points. ( see fig. # 1) After installation, insert two straps as shown in fig. # 2 and secure cooler by wrapping straps around cooler and back through the "cam lock" buckle. Cinch the straps down tightly by pulling the strap through the buckle. When properly installed the straps will securely hold the cooler in place. Secure loose ends of straps by wrapping or tying them around the section of strap behind the cooler. Straps are wearable parts and must be inspected frequently for damage and wear. Although the straps are manufactured using a high quality, UV and weather resistant material, over time, exposure to sun and other elements will slowly deteriorate them. Inspect daily, and always replace damaged or worn straps before use.

Hardware bag contents: Two four foot straps with cam lock buckles.

Return to WC-1 page

Home | All Products | Open Trailer | Enclosed Trailer | Sulkies | Blade Blocker
| Videos | Links | Instructions | Warranties | TT's Tips | E-mail Us